82-03 Harley Sportster Hardtail
(Includes: Hardtail, Oil Tank, Battery Box, and Axle)
AXLE ADJUSTER KIT NOW INCLUDED!!
Frame stretch 2 1/2"
Approximately 4" of ground clearance depending on what tire you use.
We have put together a complete kit for you that includes a lot of the parts you will need for your hartail conversion project.
All of these parts are made by us, right here in the United States!
Hardtail Frame. Our frames are made from 1 1/4" D.O.M. tubing, Tig welded and are extremely easy to install.
THERE IS NO NEED TO REMOVE YOUR ENGINE TO INSTALL THIS KIT!
Our kit uses the lower two transmission bolts to line up the frame on the bottom, and welds to the top AND the bottom. Cheap Chinese made kits weld only to the top and rely on only the transmission bolts to hold the bottom in place. Our kit has gussets pre-fit and welded to the hardtail section so you can weld it to the bottom of your frame as well as the top. All of the tubing and Axle plates are TIG welded.
Oil Tank. We build our own oil tanks specifically for this frame. It mounts in 3 locations and comes with all of the mounting hardware and bracket pre-welded to the frame. It has domed end caps on both side, return lines bungs on the top, feed line bung on the bottom and we added an extra drain bung to the left side for changing oil. We pressure test the tanks for leaks prior to shipping. The tanks are 100% TIG welded.
Battery Box. We have designed a truely unique battery box for our frames. Our batter box not only gives you a place to mount your battery, but it also covers the original swingarm pivot point on your original frame as well as the cut off tubes left from cutting your frame, leaving you with a very "finished" appearance. Not to mention, it looks SICK!
Axle. Finally, you are going to need an axle, ours FIT. We make the axle specifically for this frame. It is made from bearing grade stainless steel.
You can literally convert your stock plain Sportster to a chopper or bobber in a weekend with this kit.
Dont settle for a cheap Chinese hunk of crap for your Harley. Your going to spend just as much when you are done. You might as well have a quality part made in the USA.
Please check availability on these frames. They are selling FAST. We generally have them in stock, but they could be up to a week out.
If you are interested in having this frame installed by us, Please call the shop.
The frame stretches the wheel base approximately 2 1/2" and will fit a 130 to 150 tire using your stock pulleys or you can do a chain conversion. Approximately 4" of ground clearance depending on what tire you use.
ASK ABOUT INTERNATIONAL SHIPPING QUOTES!
NOTE: If your scooter has a 4 speed transmission availability of an offset sprockets for a 200 rear tires is very limited.
- Item #: 0072